2.5in SSD/HDD Mounting Plate — SFF-8201 Hole Pattern
A flat mounting plate with 4 holes at the official SFF-8201 side-hole spacing for a 2.5in SATA drive, for screwing an SSD or HDD directly to a chassis, DIN rail bracket, or custom enclosure.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 80 mm |
| Y | 95 mm |
| Z | 3 mm |
About this model
SFF-8201 is the official Small Form Factor Committee specification governing 2.5in drive dimensions, including a 61.72mm horizontal hole spacing and holes positioned 14mm/90.6mm from the connector edge (76.6mm apart). Real demand for 2.5in mounting brackets/adapters is well-evidenced by multiple existing DIY enclosure/server-mount products built to this exact spec.
Fit notes
- 80x95mm plate footprint -- margin around the official 61.72x76.6mm hole spacing
- 3mm plate thickness -- rigid enough for a mounted drive, not fit-critical
- Hole positions/diameter taken directly from the official SFF-8201 spec (61.72mm horizontal, 76.6mm vertical, M3 screws, 3.4mm clearance), not assumed
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- ssd-2-5-mount-plate
- Category
- mounts
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /objects/ssd-2-5-mount-plate/model.stl
- STEP file
- /objects/ssd-2-5-mount-plate/model.step
Similar objects
Raspberry Pi 4B Wall Mounting Plate — 58×49mm Hole Pattern
A flat wall-mounting plate with 4 holes at the Raspberry Pi 4 Model B's official mounting hole spacing (58×49mm, 2.7mm diameter for M2.5 screws), for screwing a Pi board directly to a wall or panel.
80×70×4mm
VESA 100×100 Mounting Plate — Official Hole Pattern
A flat adapter plate with 4 holes at the official VESA MIS-D 100×100mm hole spacing, for mounting a monitor/panel-compatible device to any VESA-standard arm or bracket.
120×120×5mm