AA Battery Holder Tray — 30-Cell 5×6 Array
A tray that holds 30 AA batteries upright and organized in a 5×6 grid, for bulk battery storage in a count that doesn't match the fixed 16/20/25-count presets sold as ready-made holders.
Dimensions
| X | 117 mm |
| Y | 97.5 mm |
| Z | 33 mm |
Assumptions
- 14.5mm cell diameter (IEC R6/AA nominal, tolerance range 13.7-14.5mm) plus 1mm clearance
- 30mm pocket depth (~60% of a 50.5mm AA cell) -- stabilizing, not full-length enclosure
- 5×6 layout (30 cells) -- a count outside the observed 16/20/25 presets
Validation status
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.